Gigabyte GA-990FXA-UD3 User Manual page 89

B. Installing Windows XP
Before installing Windows XP, connect a USB loppy disk drive to your computer irst because you need to in-
stall the SATA RAID/AHCI driver from a loppy disk that contains the driver during the OS installation. Without
the driver, the hard drive(s) may not be recognized during the Windows setup process. First, copy the driver
from the motherboard driver disk to a loppy disk. Refer to the methods below.
Method A:
• For the AMD SB950, copy all iles in the \BootDrv\SBxxx folder to your loppy disk.
• For the Marvell 88SE9172, copy all iles in the \BootDrv\Marvell\RAID folder to your loppy disk.
For AHCI mode, depending on whether you want to install the 32- or 64-bit version, copy the iles in the
AHCI\Floppy32 or AHCI\Floppy64 folder.
Method B:
Steps:
1: Use an alternative system and insert the motherboard driver disk.
2: From your optical drive folder, double click the Menu.exe ile in the BootDrv folder. A Command Prompt
window will open similar to that in Figure 3.
3: nsert the blank formatted disk (if you're using a USB loppy disk drive, make sure it is designated as drive
A). Select the controller driver by pressing the corresponding letter from the menu and press <Enter>. For
example, from the menu in Figure 3,
• For the AMD SB950, select 3) ATi AHCI/RAID Driver for XP.
• For the Marvell 88SE9172, select 10) Marvell RAID driver. (For AHCI drive(s), select Marvell AHCI
driver.)
Your system will then automatically copy the driver iles to the loppy disk. Press any key to exit when inished.
Figure 3
- 89 - Appendix