Cancel Display; Dialer Delay; 2-Way Voice; Telephone Remote Control Answer - Go!Control 2GIG-CNTRL2 User Manual

Cancel Display

A "cancel" message will be sent to the Central Monitoring Station if the system is disarmed within a
preset period of time after an alarm is triggered. The system can be set to display that a cancel report
was sent, or for higher security, the system can be set not to display the cancel message.

Dialer Delay

If an alarm occurs, the system will delay dialing for a short time to allow you to disarm the system
in case the alarm was accidentally tripped. The dialer delay reduces nuisance traffi c to the Central
Monitoring Station and can prevent receiving fi nes that many cities impose when police respond to
a false alarm. Your installer also can program the system for no dialer delay.
✓ NOTE: The dialer delay is also known as the "abort window". It gives you time to
disarm, but doesn't delay the siren from sounding. Disarming during the abort window
can display a cancel message depending on the Cancel Display setting (see above).
❑ 30 Seconds (regular setting)

2-Way Voice

The system can connect with a Central Station operator so they can converse with people in the
premises after an alarm. The 2-way voice option allows communication to and from the Control Panel
and the Central Station. 2-way voice communications will occur after the system has made its alarm
report. Your installer sets which sensors can trigger the 2-way voice option.

Telephone Remote Control Answer

Your installer selects whether your system supports the remote telephone option or not. If the
telephone remote control answer option is turned on, the system will require calling it twice within
30 seconds for the Control Panel to answer the call. See the "Remote Control by Telephone" section
of this manual.
Installer Set Options
CANCEL DISPLAY
❑ ON (regular setting)
DIALER DELAY
2-WAY VOICE
❑ OFF ❑ ON (regular setting)
TELEPHONE REMOTE CONTROL ANSWER
❑ OFF
❑ OFF
_________ Seconds
❑ ON (regular setting)
41