Setting A Destination - Volvo NAVIGATION SYSTEM (VNS) Operating Manual

Selecting an address
Selecting a street address
Set destination Address
The system will place the cursor on Street. The
most recently selected State and City will be
pre-selected.
1. To change the state or city, use the
navigation control to move to
or City ,
2. Press ENTER, or choose among the most
recently chosen alternatives with
NOTE
The definition of a city or area may vary. It
will sometimes be an entire city, or a partic-
ular section of a city.
The system does not contain street
addresses for very small towns or villages.
In these cases, the center of the town is
used as the destination.
Alternative 1
•
Street
Select without choosing a city.
The system will provide guidance to the mid-
point of the selected street. If the street exists
in more than one city, a list of alternatives will
be displayed.
Alternative 2
1. Begin by selecting a City .
2. Select a Street
.
Selecting a street number
If the address selected has a street number,
this can be used as a specific destination.
03 Advanced user mode
1. After selecting a street, go to the
State Number
and/ row and press ENTER
or
Go directly to
.
bers will be displayed.
2. Go to Set after you have entered a street
number.
> If a street number has not been entered,
the system will guide you to the mid-
point of the selected street.
Set
Confirms the entered number.
Adjust
Returns to the previous screen.
Selecting an intersection
•
Interse.
Go to
intersects the selected street.
Start guidance
•
Go to Set to add the entered address to
the itinerary.
•
Go to Start guidance
directions to the destination.
Information
Provides information about the destination.

Setting a destination

Set . Alternative street num-
and choose a street that
to begin receiving
03
``
49