Table of Contents
Advertisement
U-12
Remote control (continued)
4) Operation commands
The operation commands confi gure the basic operation settings of this LCD monitor. The commands may not work during signal
switchover.
The operation commands have no data codes.
Operation
POWER ON
POWER OFF
FORCE POWER OFF WITH OPS*
INPUT HDMI
INPUT DVI-D
INPUT D-SUB
INPUT OPTION**
INPUT VIDEO
INPUT YPbPr
INPUT S-VIDEO
VOLUME UP
VOLUME DOWN
AUTO SETUP
AUDIO MUTE
*
Used when the OPS-compliant computer makes no response.
** OPTION can be used when an extension module is mounted on the option slot.
•
When you send the POWER ON or POWER OFF command, send the next command at intervals of at least 7 seconds.
•
It is recommended that after sending a command for video input selection, wait for at least 5 seconds to send the next
command. Otherwise, the monitor may not reply within 600 ms.
•
In the power-off mode, only the POWER ON operation command and the power status acquisition commands described in
the next paragraph work.
•
In the sleep mode, only the POWER ON and POWER OFF operation commands and the power status acquisition commands
described in the next paragraph work.
•
When no OPS-compliant module is mounted, the operation command for FORCE POWER OFF WITH OPS is unavailable.
•
When an OPS-compliant module is mounted, all the input connectors don't enter the sleep mode.
•
Use the operation command for FORCE POWER OFF WITH OPS when the OPS-compliant module doesn't respond.
ASCII
HEX
!
21h
"
22h
""
22h 22h
_r1
5Fh 72h 31h
_r2
5Fh 72h 32h
_r3
5Fh 72h 33h
_r5
5Fh 72h 35h
_v1
5Fh 76h 31h
_v2
5Fh 76h 32h
_v3
5Fh 76h 33h
r06
72h 30h 36h
r07
72h 30h 37h
r09
72h 30h 39h
ra6
72h 61h 36h
English-39
Carry out as necessary
Advertisement
Table of Contents
