Sharp MD-MS200W Service Manual page 11

3. RESULT Mode
Step No. Operation and state
Step 1 Test mode STOP state
Step 2 BASS button
Step 3 AUTO menu
Step 4 SKIP UP button x 2 times
(Or SKIP DOWN button x 8 times)
Step 5 RESULT menu
Step 6 PLAY button
Step 7 Indication of measurement value:
Tracking error offset
Step 8 SKIP UP button
Step 9 Indication of measurement value:
Focus error offset
Step 10 SKIP UP button
Step 11 Indication of measurement value:
High reflection focus gain
Step 12 SKIP UP button
Step 13 Indication of measurement value:
High reflection pit tracking gain
Step 14 SKIP UP button
Step 15 Indication of measurement value:
High reflection pit tracking balance
Step 16 SKIP UP button
• Reversing when the SKIP DOWN button is pressed
• When the VOL UP button is pressed during set value indication, the set value increases, and the new set value is stored in RAM.
• When the VOL DOWN button is pressed during set value indication, the set value decreases, and the new set value is stored in RAM.
• When the VOL UP/DOWN button is held down, the setting changes continuously, one cycle being 100 ms.
• When the STOP button is pressed while the RESULT menu appears, or during measurement value or set value indication, the mode
changes to the TEST mode stop state.
• : Measurement value
• : Set value
7. TEST/PLAY Mode
Step No. Operation and state
Step 1 Test mode STOP state
Step 2 BASS button
Step 3 AUTO menu
Step 4 SKIP UP button x 3times
(Or SKIP DOWN button x 7 times)
Step 5 TEST-PLAY menu
Step 6 When the DISP button is pressed, the
process proceeds to (7).
When the PLAY button is pressed, the
process proceeds to (9).
Step 7 TEST-PLAY mode
Step 8 PLAY button
Step 9 Continuous playback (pit section)
Continuous playback (groove section)
Step 10 STOP button
Step 11 Test mode STOP state
Step No.
Display
[ T E S T ] Step 17
Step 18
[ A U T O ]
Step 19
Step 20
[ R E S U L T ]
Step 21
[ T E O : ]
Step 22
Step 23
[ F E O : ]
Step 24
Step 25
[ H f _ _ ]
Step 26
Step 27
[ H g _ _ ]
Step 28
Step 29
[ H b _ _ ]
Display
[ T E S T ]
[ A U T O ]
[ T _ P L A Y ]
[ A d 0 0 5 0 ]
[ S Q ]
[ A P ]
[ T E S T ]
– 11 –
MD-MS200W/MD-MS200/MD-MS200H
Operation and state
Indication of measurement value:
Low reflection focus gain
SKIP UP button
Indication of measurement value:
Low reflection tracking gain
SKIP UP button
Indication of measurement value:
Low reflection pit tracking balance
SKIP UP button
Indication of measurement value:
Low reflection TOTAL signal level
SKIP UP button
Indication of measurement value:
Low reflection groove tracking gain
SKIP UP button
Indication of measurement value:
Low reflection groove tracking balance
STOP button
Test mode STOP state
Display
[ L f _ _ ]
[ L g _ _ ]
[ L b _ _ ]
[ G l _ _ ]
[ G g _ _ ]
[ G b _ _ ]
[ T E S T ]