Assembly; Beginning Assembly; Power - Grizzly G8030 Instruction Manual

SECTION 4: ASSEMBLY

Beginning Assembly

All die-cut metal parts have a sharp edge
(called "flashing") on them after they are
formed. This is removed at the factory.
Sometimes, though, a bit of flashing might
escape inspection. Please examine the
edges of all die-cut metal parts before han-
dling them or serious injury may occur.
!
Most of your Model G8030 Overarm Router has
been assembled at the factory, but some parts
must be assembled or installed after delivery. We
have organized the assembly process into steps.
Please follow along in the order presented here.
TOOLS REQUIRED: You will need a straight-
edge, 12mm, 14mm, 15mm open end wrenches,
and a 3 mm Allen ® wrench.
-10-
Disconnect power to the
machine when perform-
ing any maintenance,

assembly

or adjust-
ments. Failure to do this
may result in serious
personal injury.
Keep loose clothing
rolled up and out of the
way of machinery and
keep hair pulled back.
Wear safety glasses dur-
ing the entire assembly
process. Failure to com-
ply may result in serious
personal injury.
Power Panel
The power panel at the rear of the Model G8030
must be properly wired with a safe ground. The
green wire is the ground wire and is usually the
wire on the right when facing the panel as shown
in Figure 2. Please read Section 2: Circuit
Requirements for further information on wiring.
Figure 2. G8030 power panel, with ground wire
on right.
G8030 3 H.P. Overarm Router