Table of Contents
Advertisement
Linking in Broadcasting Mode
Here's how to link your Keyboard to one or more PIPElines in Broadcasting
mode.
1.
Turn on your Keyboard. Turn on your PIPEline(s), the white LED will
blink.
Setup Procedure
Connect the Audio
•
Set up the PIPEline audio outputs to headphones; an audio mixer; or
integrated amp and speakers.
On the Rear Panel of your Keyboard
•
Use the Channel Select Knob to set the Channel Number.
On each PIPEline
2.
Set the CH switch to Ch1, Ch2, or Ch3 to match the Keyboard
Channel Selector.
3.
Set the B/P switch to the (-) position (Broadcasting mode).
4.
Set the R/T switch to the (-) position (Receive).
5.
Set the D/A switch to the (+) position (Analog).
Link Procedure
On the Rear Panel of your Keyboard
•
Press the Connect button.
On each PIPEline
6.
Press the Link/Connect button. The white LED will stop flashing
when connected.
7.
Repeat the Link Procedure for each PIPEline.
8.
Play your Keyboard. You will hear audio from each PIPEline linked to
your Keyboard.
•
If you change channels, the Keyboard and PIPEline will automatically
re-link. (Of course, the Keyboard and PIPEline channels must match!)
•
If you turn off the Keyboard, PIPEline, or both; they will automatically
re-link when you turn them back on.
•
You only have to perform the Link procedure again if you decide to link
to a different PIPEline, or if you change Paired/Broadcast modes.
12
LONGboard
SHORTboard
61
49
Hide quick links:
Advertisement
Table of Contents
