Table of Contents
Advertisement
3.0
OPERATOR CONTROLS
3.01
INVERTER MIG Series controls
1.
Main Circuit Bleaker— Switching to the ON position energizes the welding power source.
2.
Wire Feed Speed Control.
3.
Voltage Control.
4.
14-Pin Receptacle— Used to connect the wire feeder.
5.
Positive Terminal— 50mm Screw receptacle.
6.
Negative Terminal— 50mm Screw receptacle.
7.
Terminal— Use to connect the torch.
8.
Selector Control— 2T / 4T
9.
Inductance Control.
10. Meter Selection.
11. Digital Meter.
12. Warning Indicator— Activates under the following conditions:
Input voltage is too low/ too high
Thermal overload
13. AC Power Indicator— Lights when in the ON position.
14. Input Gas Fitting.
15. Fuse.
BOSS Inverter Mig 165¡¢ 200 Operating Manual
Figure 2
- 11 -
Advertisement
Table of Contents
