Starting Windows® With Tv Display Enabled; Using Scart Connectors For European Tvs - ATI Technologies Radeon X300 Series User Manual

Starting Windows® with TV Display Enabled
The TV screen may become scrambled during the initial Windows® logo
display. This distortion is only a temporary effect, and your screen will be
restored within a few seconds.
During start up, your RADEON™ X300 Series will go through a sequence
of mode settings, during which your TV display will remain blank. This
process takes only a few seconds and programs the TV display.
To enable or disable the TV display
1
Access the Windows® Control Panel . Double-click Display .
2
Click the Settings tab and then the Advanced button.
3
Click the ATI Displays tab. Click the TV button.
4
Click the enable button
5
Click OK or Apply to save the changes.
Using SCART Connectors for European
TVs
Connect to
TV or VCR
SCART
CONNECTOR
The above illustration shows how to connect your PC to a European TV
using the SCART.
The SCART connector supports only the Composite video format, which
means you will have to use an S-Video-to-Composite video adapter cable
if your card only supports the S-Video connector.
If your European TV has S-Video In, you can use an S-Video cable
(available in most consumer electronic stores) rather than the SCART
connector if your card only supports the S-Video connector.
The RADEON™ X300 Series that only has the Composite out connector
DOES NOT support connection to TVs with S-Video In.

Using SCART Connectors for European TVs 35

or disable button
(Right = red)
Audio In
(Left = white)
Audio Cable
Composite Cable or
S-Video-to-Composite Adapter Cable
Composite Video-In (yellow)
accordingly.
Connect to PC
Audio Out
Connect to PC
TV Output