Advertisement
31833137.fm Page 14 Friday, July 9, 2004 2:37 PM
HOO B00 - B01
HOO B20 - B24
1. Control panel.
2. Grease filter (1 or 2 pieces depending on model).
3. Grease filter spring release handles.
4. Lighting unit.
5. Pull-out steam deflector.
6. Extractor unit body.
Removing and/or washing the grease filter/s
1. Disconnect the electrical power supply.
2. Remove the dirty grease filter/s by pulling the handle
first backwards and then downwards (Fig. 1).
3. After cleaning the grease filter refit in reverse order,
making sure the entire extraction surface is covered.
Replacing bulbs
1. Disconnect the electrical power supply.
2. Use a small screwdriver or any other suitable tool to
prise off the lamp cover (Fig. 2).
3. Remove the burnt-out bulb.
4. Replace using 40 W max E14 bulbs only.
5. Replace the lamp cover so that it clicks into position.
Fitting or renewing the carbon filter:
1. Disconnect the electrical power supply.
2. Remove the grease filter/s (Fig. 1).
3. If the carbon filters are already mounted (one or two
filters, depending on the model. covering the motor
protection grille) and need renewing, turn the central
handle (Fig. 3 - c) anticlockwise until the filters release.
4. If the carbon filters are not already mounted, locate the
filters to cover the motor protection grilles (two
protection grilles - two carbon filters, one protection
grille - one carbon filter), then turn the central handle
(Fig. 3 - c) of the filters clockwise.
5. Refit the grease filter/s (Fig. 1).
5019 318 33137
PRODUCT SHEET
CONTROL PANEL
Light switch.
The switch has two positions (lights OFF - lights ON).
To switch on the lights: move the switch to the right.
Motor switch.
The extraction speed switch has 3 settings, depending
on the amount of steam and fumes.
To increase the extraction speed: move the switch to
the right.
Fig. 1
Fig. 2
Fig. 3
S
N
DK FIN GB
Advertisement
