Operation - American DJ X-Move Laser User Instructions

X-Move Laser
FHRS
- With this function you can display the running time
of the fixture.
1. Tap the MENU button until "FHRS" is displayed, press
ENTER.
2. The display shows the running time of the unit. Press MENU
to exit.
VER
- With this function you can display the version soft-
ware of the unit.
1. Tap the MENU button until "VER" is displayed, press ENTER.
2. The display will now display the version of software. Press
MENU to exit.
RSET
- Use this function to reset the unit.
1. Tap the MENU button until "RSET" is displayed, press ENTER.
2. The fixture will now reset
American DJ - www.americandj.com - X-Move Laser Instruction Manual Page 15
© ®
System Menu X-Move Laser
CAUTION IMPORTANT! When installing this projector, make sure
that it is mounted in a manner that prevents the audience from
looking directly into the beam, and the beam from striking the
audience.
Operating Modes: The X-Move Laser can operate in three dif-
ferent modes. In each mode you can run the fixture as a stand
alone fixture or in a master/slave confiugration.
• Sound Active mode -
The fixture will react to sound, chasing through the built-in programs.
• Show mode -
The fixture will run one of four shows that you choose.
• DMX control mode -
This function will allow you to control each individual fixtures traits
with a standard DMX-512 controller such as the Elation
Designer.
Master-Slave Operation
units together and operate without a controller. The units will be sound
activated. In Master-Slave operation one unit will act as the controlling
unit and the others will react to the controlling units programs. Any unit
can act as a Master or as a Slave.
1. Using approved DMX data cables, daisy chain your units togeth-
er via the XLR connector on the rear of the units. Remember the
Male XLR connector is the input and the Female XLR connector
is the output. The first unit in the chain (master) will use the female
XLR connector only - The last unit in the chain will use the male
XLR connector only. For longer cable runs we suggest a termina-
tor at the last fixture.
2. On the Master unit find your desired show and set that show by
pressing the ENTER button.
3. On the slave units
played, and Press ENTER. Choose either
press ENTER. Please see page 13 for more info.
4. The slave units will now follow the Master unit.
Universal DMX Control:
universal DMX-512 controller to control the chases and patterns,
©
™
This function will allow you to link up to 16
tap the MENU button until "SLND" is dis-
This function allows you to use a Elation
American DJ - www.americandj.com - X-Move Laser Instruction Manual Page 16
®

Operation

Show
®
"SL 1" or "SL 2" and
®