Advertisement
Fireplace Installation
1. Make sure the unit's Main ON/OFF switch is switched OFF (refer
to operating instruction section).
2. Plug the unit into a 15 Amp, 120 VAC outlet. If the cord does not
reach, you may use a No. 14 AWG minimum size extension cord
rated for a minimum of 1875 Watts.
Operation (Figure 3)
To access the controls, swing down the front cover panel located on
the lower front of the fireplace (refer to diagram below).
Figure 3
C
A. Main Three Position ON/OFF Switch
The switch has two ON positions marked with and
"Manual" position is for manual operation. In this position the built-in
remote control is by-passed.
The position is for operating the unit with the provided remote control.
When in position, the unit is operated with the ON and OFF buttons
of the remote control.
When the switch is in the center position the unit is off.
B. Heater ON/OFF Switch
The Heater ON/OFF Switch supplies power to the heater fan and the
heater element. When the switch is in the ON position the heater
operates if the thermostat calls for heat.
C. Heater Thermostat Control
To adjust the temperature to your individual requirements, turn the
thermostat control clockwise all the way to turn on the heater. When
the room reaches the desired temperature, turn the thermostat knob
www.sylvane.com 1-800-934-9194
B
5
A
"Manual". The
Hide quick links:
Advertisement
