Table of Contents
Advertisement
Tuners
Components Needed
Guitar Neck ....................................................... 1
Bushings ............................................................ 6
Tuning Head Plate ............................................. 1
Black Screws #3 x
⁄
" ....................................... 7
3
8
Wooden Block ................................................... 1
Hammer ............................................................. 1
Peghead Reamer or a Round File (Optional) ... 1
The tuning head plate consists of six machine
heads on a metal plate. The machine heads are
attached to the headstock with bushings and
small screws.
To install the tuners:
1.
Place the six bushings into the holes on the
face of the headstock (Figure 6). The holes
may need to be widened with a peghead
reamer or a round file. DO NOT widen the
holes too much—the bushings should fit
snugly.
Figure 6. Installing plastic bushings on head-
stock.
2.
Place a wooden block on the bushings and
lightly tap the block with a hammer (Figure 7)
until the bushings are seated against the face
of the headstock.
Model H7582 Junior Electric Guitar Kit
Qty
Figure 7. Seating bushings.
3.
Slide the machine heads through the bush-
ings from the back face of the headstock.
4.
Align the tuning head plate over the mounting
holes and secure with #3 x
as shown in Figure 8.
Figure 8. Tuning head plate installed correctly.
NEW
NEW
PHOTO
PHOTO
⁄
" black screws
3
8
-9-
Advertisement
Table of Contents
