Pmk 350 Mounting - Extron electronics FOX 3G HD-SDI User Manual

PMK 350 mounting

Mount the transceiver to a PMK 350 bracket as follows:
1.
Remove the front and rear plates from the PMK 350 (figure 13), using a Tweeker or a
#2 Phillips screwdriver . Retain the screws to reattach the plates when you are finished.
Rear Plate
Extron
PMK 350
Multi-product Pole
Mount Kit
Figure 13. PMK 350 Projector Mounting a Transceiver
2.
If necessary, remove the feet from the bottom of the transceiver.
3. Secure the transceiver to one side of the mounting tray, using two of the supplied
4-40 x 3/16-inch screws in opposite (diagonal) corners.
4. If power supply is connected to the transceiver, use the two included tie wraps to strap
the power supply to the bracket.
5.
Place the PMK 350 around the projector ceiling mounting pole (figure 13).
U-bolt
Extron
Power Supply
Cover Sheet
FOX 3G HD-SDI • Reference Information
Extron
Quarter-rack
Sized Product
Contoured
Base
L-shaped
Bracket
Front Plate
20