Allied Telesis AT-8600 Series Installation And Safety Manual page 11

10
9. Apply AC power to the switch
Plug the power cord into the AC power connector. This is on the switch's
rear panel, as shown in the below figures.
Figure 1: AT-8624T/2M front and rear panel with AC power inlet.
25 26
Figure 2: AT-8624PoE front and rear panel with AC power inlet
25 26
Figure 3: AT-8648T/2SP front and rear panel with AC power inlet
LINK 49R MODE
49
LINK
SFP
LINK
LINK 50R MODE
50
10. Check that the PWR LED on the switch's front panel lights green
If the PWR (power) LED fails to light, refer to the AT-8600 Series Hardware
Reference for troubleshooting information.
11. Connect the data cables
Make sure each cable connection is secure. The switch will now perform
basic Layer 2 switching functions.
1 3 5 7 9 11
2 4 6 8 10 12
1 3 5 7 9 11
2 4 6 8 10 12
CLASS 1
LASER PRODUCT
DO NOT STARE
INTO BEAM
13 15 17 19 21 23
LINK
MODE
LINK
MODE
14 16 18 20 22 24
13 15 17 19 21 23
14 16 18 20 22 24
AT -8600 Series Switch
AT-8624T/2M
Layer 3 Fast Ethernet Switch
MODE RS-232
1 3 5 7 9 11 13 15 17 19 21 23
TERMINAL PORT
COL
100
FULL
ACT
2 4 6 8 10 12 14 16 18 20 22 24
AT-8624POE
100 LINK ACT 10 LINK ACT
FULL DUP HALF DUP COL
PD ON PD ERR MAX CURRENT
MODE
RS-232
1 3 5 7 9 11 13 15 17 19 21 23
TERMINAL PORT
2 4 6 8 10 12 14 16 18 20 22 24
AT-8648T/2SP
STATUS
FAULT
MASTER
RPS
PWR
Layer 3 Fast Ethernet Switch
STATUS
FAULT
MASTER
RPS
PWR
Layer 3 Fast Ethernet Switch
STATUS
COL FLT
SPD MSTR
FDX RPS
ACT PWR
MODE