Searching For Your Code - One for All 6-DEVICE PVR User Manual

OFA 6 PVR 2/15/03 9:25 AM
5. If you've located a setup code that works,
but it also has a separate VCR code, you'll
also need to program it into the remote
control to access VCR controls as follows:
a. Press
b. Enter the VCR code for your DVD
NOTE: If a separate VCR setup code is not listed,
you can use the VCR key to program a separate
VCR device or another device (see "Re-Assigning
Device Keys"on page 15)
6. For future reference, write down the
working DVD Player/VCR combo code in
the below boxes:
DVD/VCR
VCR
(if used)

SEARCHING FOR YOUR CODE

If your device does not respond to the remote control
after trying all codes listed for your brand, or if your
brand is not listed at all, try searching for your code.
For example, to search for a code for your TV:
1. On the remote control, press
2. Press and hold
blinks twice, then release
3. Enter
4. Aim the remote control at the the TV and
slowly alternate between pressing
and
NOTE: In the search mode, the remote control
will send IR codes from its library to the selected
device, starting with the most popular code first.
5. To lock in the code, press and release
The
6. To search for the codes of your other
devices, repeat steps 1 through 5, but
substitute the appropriate device key for
the device you are searching for.
Page 11
once. Then press and hold
VCR
the key until the
SET LED
Player/VCR Combo. If correct, the
will blink twice.
Code:
Code:
until the
SET
SET
- - . The will blink twice.
9 9 1 LED
. Stop when the TV turns off.
TV
will blink twice.
LED
11
blinks twice.
LED
once.
TV
(red light)
LED
.
POWER
.
SET