Programming Combo Device Control; Searching For Your Code - One for All 6-Device Universal Remote with Learning User Manual

O F A
NE OR LL
Brand Name:_____________________
AUD Code:
Brand Name:_____________________
PROGRAMMING COMBO
DEVICE CONTROL
You can set the One For All 6L Universal
Remote Control with Learning (URC-6820
B00) to control your combo devices such as
TV/VCR, TV/DVD, Satellite/PVR/DVR,
Home-Theater-In-A-Box, and many others
with a single code. For a complete list of
combo devices, refer to the "Device Table"
on page 5.
NOTE: Some combo device types have codes
that you can program on separate device
keys. For example, you can program DVD
Player/VCR Combo codes under the VCR or
DVD mode keys. See "Setup Codes for DVD/
VCR Combos (Codes de réglage des lecteurs
DVD/magnétoscopes)" on page 59; note that
there are two sections under this device type.
Perform the following instructions to
control a TV/DVD Combo:
1. Turn on the TV/DVD Combo and insert
a DVD.
NOTE: Please read steps 2 through 4
completely before proceeding. Highlight or
write down the codes and device you wish to
program before starting step 2.
On the remote control, press TV.
2.
3. Press and hold SET until the LED (red
light) blinks twice, and then release
SET.
4. Use the Setup Codes under the TV/
DVD Combos heading (use codes listed
as "TV Codes") on page 56. Locate the
8

Programming Combo Device Control

6L U R
NIVERSAL
C
EMOTE ONTROL WITH
brand name and then enter the first
four-digit code for your device. If
performed correctly, the LED will blink
twice.
NOTE: If the LED did not blink twice, repeat
steps 2 through 4 and enter the same code
again.
5. Aim the remote control at the device
and press POWER once. It should turn
off. If the device does not respond,
repeat steps 2 through 4, trying each
code for your brand until you find one
that works. If it still does not work, try
"Searching for Your Code", below.
SEARCHING FOR YOUR
CODE
If your device does not respond to the
remote control after trying all codes listed
for your brand, or if your brand is not listed
at all, try searching for your code. For
example, to search for a code for your TV:
1. Turn on your TV and on the remote
control, press TV once.
2. Press and hold SET until the LED (red
light) blinks twice, then release SET.
3. Enter 9 9 1. The LED will blink twice.
4. Select a test function from the list
below or use the default test function
(POWER) and skip step 4.
NOTE: The keys that can be used for the test
function are 0, 1, 2, 3, POWER, VOL +, Play,
Stop and Mute.
5. Press CH+ to begin searching for your
code. Stop the search when the device
turns off or performs the function
selected in step 4 (if other than
POWER).
L
EARNING