Table of Contents
Advertisement
1. PASSIVE ARMING (LAST DOOR ARMING )
"without". If set "with", when ignition is off, the driver leaves the vehicle and closes doors well, 25 seconds after,
the system will be armed automatically. (if set "with" this feature, then the previous AUTOMATIC ARMING
ALERT feature will be invalid).This is to protect your vehicle in the event you forget to arm the system using the
transmitter. You can choose whether you want to set "with" this feature according to your personal practice. To
select "with" this feature, please see below PROGRAMMABLE OPERATION TABLE.
2. IGNITION TRIGGERED DOOR LOCK/UNLOCK This feature is programmable. Factory setting is
"without". If set "with", the system will lock the doors automatically when the ignition is turned on while doors
are closed well (if doors are not closed well or ignition is not turned on, then it will not lock) and unlock when
turned off. To select "with" this feature, please see below PROGRAMMABLE OPERATION TABLE.
3. DOOR OPEN ALERT This feature is programmable. Factory setting is "without". If set "with", then before
driving, any doors are not closed well, if ignition is not ON, then the vehicle lights will flash for 30 seconds
unless the doors are closed well, if ignition is ON position, then the vehicle lights will flash all the time until the
doors are closed well. This is to give warning to driver to close door also give warning to other vehicles behind
to keep away from this vehicle. To select "with" this feature, please see below PROGRAMMABLE
OPERATION TABLE.
PROGRAMMABLE FEATURE TABLE:
FEATURE
PASSIVE ARMING
(LAST DOOR ARMING)
IGNITION TRIGGERED
DOOR LOCK/UNLOCK
DOOR OPEN ALERT
VALET MODE
Note: to set "with", step 1 to step 2, must operate within 5 seconds. Before setting, the system must be in disarmed
mode.
1. MAIN UNIT INSTALLATION
unit should be installed in a hidden location where it is not subject to high temperature, moisture and away
from other electronic equipment in the vehicle. Normally it is placed under instrument panel close to the
driver's seat. The driver must keep in mind the position of the main unit specially the special anti-robbery
switch placement (green button on main unit) so he can use it when needing anti-hijacking feature in danger.
Insert the harness plug into the main unit, use tape to secure the front end of the harness, then locate the
vehicle ignition wires, parking light wires, footbrake wire, door opening signal, power supply wire etc,
connect them with main unit related wires according to the circuit diagram. The Antenna on main unit must
5
PROGRAMMABLE FUNCTION AND FEATURES
1. Turn Ignition Switch
from OFF to ON
3 cycles
( stop at "ON")
4 cycles
( stop at "ON")
5 cycles
( stop at "ON")
6 cycles
( stop at "ON")
SYSTEM INSTALLATION INSTRUCTION
Determine the installation location of the main unit first. The main
This feature is programmable. Factory setting is
TO SET "WITH"
2.Transmitter
3.
Operating
Confirmation
Press Button
2 chirps
A for 3
3 flashes
seconds
Press Button
2 chirps
A for 3
4 flashes
seconds
Press Button
2 chirps
A for 3
5 flashes
seconds
Press Button
2 chirps
A for 3
6 flashes
seconds
TO EXIT "WITH"
Operation
Confirmation
press button
1 chirp
B for 3
3 flashes
seconds
press button
1 chirp
B for 3
4 flashes
seconds
press button
1 chirp
B for 3
5 flashes
seconds
press button
1 chirp
B for 3
6 flashes
seconds
Advertisement
Table of Contents
