Megalarm MEGA 2700 Operation Manual

2-way lcd pager alarm with remote engine starter

Advertisement

Quick Links

MEGA 2700
2-WAY LCD PAGER ALARM WITH
REMOTE ENGINE STARTER
Operation Manual
MEGATRONIX
CHATSWORTH, CA U.S.A.
MEGA 2700 OPERATE
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MEGA 2700 and is the answer not in the manual?

Questions and answers

Summary of Contents for Megalarm MEGA 2700

  • Page 1 MEGA 2700 2-WAY LCD PAGER ALARM WITH REMOTE ENGINE STARTER Operation Manual MEGATRONIX CHATSWORTH, CA U.S.A. MEGA 2700 OPERATE...
  • Page 3: Remote Transmitter Operation

    WARNINGS: As with any product that performs automatic functions, there are certain safety precautions that you must practice and be aware of. 1. Keep the transmitter out of children’s reach. 2. Do not leave anyone in the vehicle while running on remote control. 3.
  • Page 4: Active Arming - Lock & Arm

    F. ACTIVE ARMING – LOCK & ARM: 1. Press button on the transmitter. 2. The siren will chirp once and parking light will flash once indicating that the system is now armed. The vehicle door will lock and dome light turns on for 10 seconds upon arming when interfaced with the security system.
  • Page 5: Disarming Without A Transmitter

    TWO STEPS DOOR UNLOCK (See Alarm Feature “II 1” Programming): This feature will independently unlock the driver’s door only when disarming the security system. Pushing the button a second time within 3 seconds will unlock the other doors. AUTOMATIC RE-ARM (See Alarm Feature “ 3”...
  • Page 6: Trigger The System

    3. To stop the alarm, press and hold the transmitter button on the transmitter again for 3 seconds. Also if any transmitter buttons other than button is pressed and released, the panic mode will be turned off immediately. 4. If the button is not pressed, the alarm will automatically stop after 30 seconds. M.
  • Page 7 P. IGNITION CONTROL DOOR LOCK/UNLOCK. II – 2 (See Alarm Feature Programming). If the vehicles door locks have been interfaced to the security system, the system will automatically lock the vehicle's doors when the ignition is turned “ON” and /or unlock the vehicle’s doors when the ignition is turned “OFF”...
  • Page 8 Note: If the brake pedal is pressed before the key is in the ON position, the engine will shut down. C. TEMPORARY STOP FEATURE: This feature allows the vehicle to remain running after the key has been removed from the ignition. This feature is useful for occasions when you wish to exit and lock the vehicle for short periods of time, but would like to leave the motor running and the climate control on.
  • Page 9 7. The vehicle refused to start running after {3} unsuccessful attempts. I. DISABLING THE REMOTE START SYSTEM: (If installed) This feature allows your system’s remote start unit to be temporarily disabled to prevent the vehicle from being remote started accidentally. This feature is useful if the vehicle is being serviced or stored in an enclosed area.
  • Page 10 1. Second Vehicle Security Operation: Your remote transmitter can be utilized to control a second vehicle security system. To program the remote control transmitter to a second vehicle, follow the instructions for Transmitter programming. All programming parameters be the same except for the following: For Regular Remote Control Transmitter: 1.

Table of Contents