Resistance Measurement - UNI-T UT30B Operating Manual

Model UT30B/C/D/F: OPERATING MANUAL
G.Make Measurements(7)
5. Resistance Measurement (see figure 6)
1) To avoid damages to the Meter when
measuring resistance, cut off the power
of the object and make sure there is no
charge in capacitor.
2) Test lead wires take 0.1 -0.3 tolerance
when measuring resistance. To get an
accurate reading, subtract the short circuit
values of the 2 test leads.
3) It will take several seconds for the display
to become stabilized when resistance value
is over 1M
23
(figure 6)