Technical Service; Replacement Parts And Accessories; Repair Service; Warranty Service - Remington RPS 96 104317 Owner's Manual

OPERATING CHAIN SAW
Continued
TRIMMING A TREE (PRUNING)
WARNING: Avoid kickback. Kick-
back can result in severe injury or death.
See Kickback, page 3, to avoid risk of
kickback.
WARNING: Do not operate Pole Saw
while
• in a tree
• on a ladder or any other unstable sur-
face
• in any awkward position
You may lose control of Pole Saw caus-
ing severe injury.
WARNING: Do not extend arms
above shoulders when using Pole Saw.
CAUTION: Seek professional help if
facing conditions beyond your ability.
Trimming a tree is the process of cutting limbs from
a living tree. Make sure your footing is firm. Keep
feet apart. Divide your weight evenly on both feet.
Follow directions below to trim a tree.
1. Make first cut six inches from tree trunk on un-
derside of limb. Use top of guide bar to make
this cut. Cut 1/3 through diameter of limb (see
Figure 18).
2. Move two to four inches farther out on limb.
Make second cut from above limb. Continue cut
until you cut limb off.
3. Make third cut as close to tree trunk as possible
on underside of limb stub. Use top of guide bar to
make this cut. Cut 1/3 through diameter of stub.
4. Make fourth cut directly above third cut. Cut down
to meet third cut. This will remove limb stub.

TECHNICAL SERVICE

You may have further questions about assembling,
operating, or maintaining this product. If so, you can
visit our Technical Service web site at
www.desatech.com or contact our Technical Ser-
vice Department at 1-800-858-8501 (English Only).
You may also write to:
DESA Specialty Products™
P.O. Box 90004
Bowling Green, KY 42102-9004
ATTN: Technical Service Specialty Products
www.desatech.com
When contacting DESA Specialty Products™, have
ready
• Your Name
• Your Address
• Your Phone Number
• Model Number of Product
• Date of Purchase (Include copy of receipt for
written requests).
REPLACEMENT PARTS
AND ACCESSORIES
WARNING: Use only replacement
parts and accessories described in this
manual. Use of other parts or accessories
could damage saw or injure operator.
For original replacement parts and accessories, con-
tact your nearest Authorized Dealer or Authorized
Service Center for this product. If they can not sup-
ply the part or accessory, contact your nearest Parts
Central listed on page 30. Each Authorized Dealer,
Authorized Service Center, and Parts Central is in-
dependently owned and operated.
See pages 28 and 29 for an Illustrated Parts List.
If you need additional referral information, contact our
Technical Service Department (see Technical Service).
In Canada call 1-800-561-3372 for parts information.

REPAIR SERVICE

Note: Only use original replacement parts. This will
protect your warranty coverage for parts replaced
under warranty.
Each Authorized Service Center is independently
owned and operated.

WARRANTY SERVICE

If product requires warranty service, return it to near-
est Authorized Service Center. You must show proof
of purchase. If faulty materials or workmanship caused
damage, we will repair or replace product without
charge. Note: Normal wear, misuse, abuse, neglect,
or accidental damage is not covered under warranty.
NON-WARRANTY SERVICE
If product requires service, return it to nearest Au-
thorized Service Center. Repairs will be billed to you
at regular repair list prices.
For additional Service Center or warranty informa-
tion, call 1-800-858-8501 or visit our Technical Ser-
vice web site at www.desatech.com.
16
108540