Table of Contents
Advertisement
Vax_V-082i.qxd
8/5/06
How to Assemble / How to Operate
3. How to Assemble
IMPORTANT: Never remove the water tank during
use. The tank is under pressure.
IMPORTANT: Do not operate a damaged appliance
or damaged accessories.
IMPORTANT: The steam cleaner is not intended for
commercial use.
NOTE: Carpets should be dry vacuumed thoroughly
before using the steam cleaner.
NOTE: If the supply cord is damaged, it must be
replaced by the manufacturer, a Vax service agent or
similarly qualified persons in order to avoid hazard.
1. Insert the handle and the extension tubes into each
other. (Fig. 3/1).The locking catch clicks audibly
into place.
Fig.3/1
2. Insert the jointed connection into the floor head
Turn it 180° to lock it into position (Fig. 3/2).
Fig.3/2
3. Push the floor head, with the jointed connection,
onto the lower end of the extension tube (Fig. 3/3)
Fig.3/3
4. Push the accessories mount onto one of the
extension tubes. Then push both the brushes and the
jet nozzle onto the accessories mount (Fig 3/4).
4
17:58
Page 5
Fig.3/4
4. How to Operate
Filling the tank
1. Pull the release button back and remove the water
tank from the back by tipping it (Fig.4/1)
Fig.4/1
2. Unscrew the cap, fill the water tank with tap water
and then screw the cap down again. (Fig. 4/2)
Fig.4/2
3. Place the water tank back into the steam cleaner by
pressing the rear of it down first. Then lock it into place
by pushing forwards. The locking catch clicks audibly
into place.
4. Plug the steam cleaner mains plug into a properly
installed socket by pulling the cable out of the main
body.
Using the steam cleaner
1. Switch the steam on using the on/off switch. The
steam level indicator light will come on (Fig. 4/3)
Fig.4/3
Advertisement
Table of Contents
