Peripheral Unit Drive Circuit - Star Micronics DP8340 Series User Manual

8-7. Peripheral Unit Drive Circuit

The Control Board of this unit is equipped with a circuit for driving a peripheral
unit (Paper Cutter, Take-Up Device, Cash Drawer, etc.)
The Control Board Connector (CN3) is used to connect the Peripheral Unit to
the Drive Circuit. When using this circuit connect the peripheral unit cable to
the CN3 Connector (cable is not included). Use a cable with the following speci-
fications:
Note: Do not run cable near devices generating large amounts of electrical
noise.
Figure 8-7. Cable Specifications
– 32 –