Table of Contents About Your New Dodge Viper ..................1 Service and Repairs ....................... 1 Parts List ........................2 Attach Rear Wheels......................3 Attach Front Wheels....................... 3 Install Dashboard Assembly ..................4 Install Left and Right Mirrors..................4 Install Steering Rod and Steering Wheel................ 5 Charge 12-Volt Battery Prior to Final Assembly ............6-7 Recharging the Battery ....................
• Provide the serial number, found underneath the Dodge Viper’s seat on the car body and a brief description of the part. • If your Dodge Viper needs service or repairs, call Kid Trax Toys Consumer Relations at (877) 741-6154 for an authorized service center.
Parts List Tools and batteries needed for assembly: • Phillips screwdriver • 4 AA alkaline batteries (for radio) Vehicle Body 2 Mirrors (left and right) 2 Large Washers Dashboard Assembly 2 Front Wheels (marked “FRONT”) Steering Wheel 2 Rear Wheels (marked “REAR”) Steering Rod 4 Wheel Covers Charger...
Attach Rear Wheels 1. Locate a wheel marked “REAR”. Slide a wheel onto the axle with “REAR” facing toward vehicle. Fit the protruding section of the wheel into the gear box. 2. Slide a wheel cover onto the axle, fitting the three locating pins into the holes in the wheel.
Install Dashboard Assembly 1. Place the dashboard on the hood of the Dodge Viper. Locate the connector under the dashboard. Firmly connect to the connector/cable from the body of the Dodge Viper. 2. Lower the front dashboard assembly onto the body of the Dodge Viper.
Install Steering Rod and Steering Wheel 1. Gently turn the Dodge Viper onto its side on a carpeted surface or other soft material to prevent damage to the side of the car. NOTE: It is helpful to have an assistant during this section. 2.
DO NOT charge the 12-volt battery if any damage to parts has occurred. Replace with Kid Trax Toys parts ONLY. • Do not allow the 12-volt battery to drain completely. Recharge the battery after each use or once a month if not used regularly.
2. Firmly plug the charger connector into the battery’s connector. Use ONLY the Kid Trax Toys 12-volt charger included with the Dodge Viper (Input: AC120V–, 0.5A, 60Hz Output: DC14.2V, 1.5A). 3. Plug the charger into a standard 120-volt wall outlet.
Install Seats 1. Locate hooks behind seats. NOTE: There are two seat positions; one for a smaller child, and one for a larger child. Install the seat so your child can easily reach the foot pedal and comfortably use the steering wheel.
• Never allow more than two (2) riders in the Dodge Viper. • The Kid Trax Toys Dodge Viper is for children aged 3 years and up. • MAXIMUM COMBINED WEIGHT IS 130 LBS. (59 KG). Do not overload the Dodge Viper.
FM Radio and MP3 Port Battery Compartment See below for battery installation. Volume and On/Off Knob To turn on the radio, turn the knob to the right. Turn the knob to the right for more volume. Turn the knob all the way to the left to turn the radio off.
Cup Holder The Dodge Viper features a slide- out cup holder located under the radio battery compartment. Push in when not in use. NOTE: Do not place a cup contain- ing hot liquid in the cup holder. It might spill, causing burns. Foot Pedal The foot pedal controls forward motion, reverse and stopping.
Rules for Safe Riding READ THESE RULES ALOUD TO YOUR CHILD AND THEIR PLAYMATES AND MAKE SURE THEY UNDERSTAND THEM! • Always drive the Dodge Viper with an adult watching. • Riders must be 3 years of age or older. •...
Driving the Dodge Viper IMPORTANT! The Dodge Viper MUST come to a complete stop before shifting into reverse and into low or high speed. Damage to the gears and motor WILL occur. Low Speed 2-1/2 mph (4 km/h) for Beginning Drivers ■...
Give water, milk of magnesia or egg whites. Do not induce vomiting. • The Kid Trax Toys 12-volt battery features a thermal fuse with a reset fuse on the circuit board that will automatically trip and cut all power to the Dodge Viper if the motor, electric system or battery is overloaded.
Take it to a federally or state-approved lead acid battery recycler, such as a Kid Trax Toys authorized service center or your local automotive battery retailer. 5. Replace the battery with a Kid Trax Toys 12-volt battery ONLY.
• Do not drive the Dodge Viper in loose dirt, sand or fine gravel, which could damage moving parts, motors or the electric system. • Kid Trax Toys recommends that you take your Dodge Viper to an authorized service center for periodic maintenance and service. Call Kid Trax Toys Consumer Relations...
POSSIBLE CAUSE: Thermal fuse has tripped. The Kid Trax Toys 12-volt battery features a thermal fuse with a reset fuse on the circuit board that will automatically trip and cut all power to the Dodge Viper if the motor, electric system or the battery is overloaded.
Page 21
The Kid Trax Toys 12-volt battery will eventually lose the ability to hold a charge. Depending on the amount of use, and varying conditions, the battery should operate for one to three years. Replace the battery with a new Kid Trax Toys 12-volt battery. See page 21 to reorder parts.
Page 22
The Kid Trax Toys 12-volt battery will eventually lose the ability to hold a charge. Depending on the amount of use, and varying conditions, the battery should operate for one to three years. Replace the battery with a new Kid Trax Toys 12-volt battery. See page 21 to reorder parts.
Replaceable Parts • Front wheel • Rear wheel • Wheel cover • Hub caps • Hardware bag for wheel assembly • Hardware bag for dash and steering column • Seat • 12-volt battery • Charger • Mirrors • Steering Wheel To order parts call (877) 741-6154.
1-800-207-8182, 24 hours a day; write to Kid Trax Consumer Relations Department, Kid Trax Toys, P.O. Box 344 Olney, IL 62450 or call 1-877-741-6154 from 8 a.m. to 5 p.m., Monday through Friday, CST. Proof of purchase is required, and shipping charges are the responsibility of the consumer.
Need help?
Do you have a question about the KT1045WM and is the answer not in the manual?
Questions and answers