Protech Systems PROX-1750 User Manual page 98

MEMORY VERIFY ERROR AT ... :
Indicates an error verifying a value already written to memory. Use the
location along with your system's memory map to locate the bad chip.
OFFENDING ADDRESS NOT FOUND :
This message is used in conjunction with the I/O CHANNEL CHECK and
RAM PARITY ERROR messages when the segment that has caused the
problem cannot be isolated.
OFFENDING SEGMENT :
This message is used in conjunction with the I/O CHANNEL CHECK and
RAM PARITY ERROR messages when the segment that has caused the
problem has been isolated.
PRESS A KEY TO REBOOT :
This will be displayed at the bottom screen when an error occurs that
requires you to reboot. Press any key and the system will reboot.
PRESS F1 TO DISABLE NMI, F2 TO REBOOT :
When BIOS detects a Non-maskable Interrupt condition during boot, this
will allow you to disable the NMI and continue to boot, or you can reboot
the system with the NMI enabled.
RAM PARITY ERROR – CHECKING FOR SEGMENT :
Indicates a parity error in Random Access Memory.
Should be Empty But EISA Board Found
PLEASE RUN EISA CONFIGURATION UTILITY :
A valid board ID was found in a slot that was configured as having no
board ID.
Note: When this error appears, the system will boot in ISA mode, which
allows you to run the EISA Configuration Utility.
Should Have EISA Board But Not Found
PLEASE RUN EISA CONFIGURATION UTILITY :
The board installed is not responding to the ID request, or no board ID has
been found in the indicated slot.
Note: When this error appears, the system will boot in ISA mode, which
allows you to run the EISA Configuration Utility.
Prox-1750G1/G2 USER
'
S MANUAL
Appendix C Trouble Shooting
Page: C-5