Manually Configuring Network Settings - Belkin F6D4230-4 User Manual

MaNUally CoNfIgURINg NETWoRK sETTINgs

sections
table of contents
Set up the computer that is connected to the cable or DSL modem FIRST using these steps� You can also use these steps to add computers to your Router
after the Router has been set up to connect to the Internet�
Manually Configuring Network settings in Mac os up to 9x
In order for your computer to properly communicate with your Router, you will need to change your Mac computer's TCP/IP settings to DHCP�
1 Pull down the Apple menu� Select "Control Panels" and select "TCP/
IP"�
2 You will see the TCP/IP control panel� Select "Ethernet Built-In" or
"Ethernet" in the "Connect via:" drop-down menu (1)�
3 Next to "Configure" (2), if
"Manually" is selected, your
Router will need to be set
up for a static IP connection
type� Write the address
information in the table
below� You will need to enter
this information into the
Router�
150N Wireless Router
1 2 3
(1)
(2)
4 5 6
4 If not already set, at "Configure:", choose "Using DHCP Server"� This
will tell the computer to obtain an IP address from the Router�
5
Close the window� If you
made any changes, the
following window will appear�
Click "Save"�
Restart the computer When the computer restarts, your network
settings are now configured for use with the Router
70
7 8 9 10