Using Keyfobs - GE Interlogix Aritech CS250 User Manual

There are 2 types of keyfobs that can be used with the system. These are wireless (RF) keyfobs and infra-red (IR) keyfobs.
RF keyfob
If you have an RF receiver with your CS250 system, you can use an RF keyfob.
There are 2 types of keyfob, one with 2 buttons and one with 4 buttons. The buttons can be programmed to perform different
functions.
An indicator LED flashes while the keyfob is transmitting to show that it is in use. The transmission range of the keyfob depends
on the battery life. You should replace the battery if the transmission range decreases.
IR keyfob
This is a 3-button device that can send commands via an infra-red keypad. There is 1large button and 2 smaller buttons.The
transmission range of the keyfob depends to a small extent on lighting conditions but is generally up to 5 metres. An indicator LED
flashes while the keyfob is transmitting to show that it is in use.
Installing, removing and programming keyfobs
To install a keyfob, select Users - User Codes - User n - Keyfob - Install Fob and press the lock and unlock buttons on the keyfob simultaneously.
To remove a keyfob, select Users - User Codes - User n - Keyfob - Remove Fob.
To program a keyfob, select Users - User Codes - User n - Keyfob - Keyfob func.
Keep a note of the button functions here:
Lock
Unlock
Light
Star
U
RF Settings
Lock
Unlock
SING KEYFOBS
RF Settings
IR Settings
OFF
A
C
A+C
CS250 User Manual 8