Inhibiting A System Tamper - GE Interlogix Aritech CS250 User Manual

If a piece of equipment has been tampered with, the trouble and status LEDs flash and the LCD displays the problem. You can inhibit a tamper to
arm the system.
1 Enter the user code. ..........
2 Press the down arrow. ................................................................
3 Press OK. ....................................................................................
4 Press the down arrow twice. .......................................................
5 Press OK. Any inhibited tamper zones are displayed. ................
6 Enter the code for the system tamper that you want
to inhibit followed by #. The inhibit is displayed. In this
example, the internal bell tamper is inhibited. .............................
I
NHIBITING A SYSTEM TAMPER
Enter Code
****
User Menu
Arm Options
User Menu
Inhibits
Inhibits
Inhibit Zone
Inhibits
Inhibit Sys Tam
Inhibit Sys Tam
None
Inhibit Sys Tam
Internal Bell
System Tamper Codes
Explanations for these can be found
in the service messages.
Code Tamper
1 Ext Tamp
2 Local Tamp
3 Int Bell Tamp
4 Ext Bell Tamp
5 - 12 Keypad Tamp 1-8
13 Bus Tamp
14 EXPN Lid Tamp
15 RF Jam Tamp 1
16 RF Ant Tamp 1
17 EXPN Lid Tamp 2
18 RF Jam Tamp 2
19 RF Ant Tamp 1
CS250 User Manual 14