Set The Controls To Manual Mode Operation - Norcold N62X Owner's Manual

- If 120 volts AC is not available to the refrigerator:
- The letters "AU" and then "AC" show in the center
display.
- After five seconds, the "AU" and then "LP" show in the
center display.
- After ten seconds, the "AU" and the "LP" go off and only
a green power ON light remains.
- This means that the refrigerator is operating on
propane gas.
- On 2-way models only, if neither 120 volts AC nor propane
gas is available to the refrigerator:
- The fault codes "no" "AC" and then "no" "FL" show in
the center display and an audible alarm sounds.
- On 3-way models only, if neither 120 volts AC nor propane
gas is available to the refrigerator:
- The refrigerator control will automatically change to DC
electric operation.
NOTE: DC electric operation is less efficient than AC
electric and propane gas. Use DC electric
operation only to maintain the refrigerator
temperature while in transit and if the other
energy sources are not available. Do not use
DC electric to initially decrease the temperature
of the refrigerator.
If an energy source is available to the refrigerator, but is not
operating correctly:
- A fault code shows in the center display.
- The refrigerator controls try to change to a less efficient
energy source.
- If a less efficient energy source is not available:
- An audible alarm starts.
- A fault code shows in the center display.
- Refer to the "Fault Codes" section of this manual.

Set the controls to manual mode operation:

- Push the ON / OFF button to turn the refrigerator on.
- Push and hold the MODE button until the letters " AC" show
in the center display and then release.
- After ten seconds, the "AC" goes off and only a green
power ON light remains.
Owner's Manual 10
- Push and hold the MODE button until the letters "LP" show
in the center display and then release.
- After ten seconds, the "LP" goes off and only a green
power ON light remains.
- Push and hold the MODE button until the letters " dC" show
in the center display and then release.
- After ten seconds, the "dC" goes off and only a green
power ON light remains.
If the energy source is interrupted:
- A fault code shows in the center display.
- Refer to the "Fault Codes" section of this manual.