Ford Mark LT Owner's Manual page 250

Roadside Emergencies
Location of the spare tire and tools
The spare tire and tools for your vehicle are stowed in the following
locations:
Tool
Spare tire
Jack, jack handle and lug nut
wrench
The wing nut must be removed and the jack screw turned
counterclockwise to release pressure before the jack can be removed
from the holder.
Removing the spare tire
1. Use the ignition key to remove
the lock cylinder from the access
hole of the bumper to allow access
to the guide tube. Assemble the jack
handle as shown in the illustration.
2. Fully insert the jack handle
through the bumper hole and into
the guide tube through the access
hole in the rear bumper.
3. Turn the handle counterclockwise until tire is lowered to the ground,
the tire can be slid rearward and the cable is slightly slack.
4. Slide the retainer through the center of the wheel.
250
2008 Mark LT (mlt)
Owners Guide (post-2002-fmt)
USA (fus)
Location
Under the vehicle, just forward of
the rear bumper
Under the rear seat on the
passenger side