Setting Up Ibft On Ipv6; Setting Up A Static Ipv6 Address; Configuring Target Settings For Ipv4 (Dynamic) - Dell Qlogic QME8242 User Manual

Figure 4-16. Configuring Target Settings for IPv4 (Dynamic)
10. Press ESC and save the settings.
11. Reboot the system.

Setting Up iBFT on IPv6

You can set up iBFT on IPv6 with either a static IP address (see
Static IPv6 Address" on page
Dynamic IPv6 Address" on page

Setting Up a Static IPv6 Address

To set up a static IP address on IPv6, follow these steps:
1. Start the server and when the NIC boot code banner appears, press
CTRL+Q.
The QLogic CNA Function Configuration utility opens to the Select Adapter
menu.
2. Select the adapter to configure, and then press ENTER.
The QLogic CNA Function Configuration utility opens to the Setup menu for
the selected adapter.
3. Under Function Configuration, select the iBFT function to configure, and
then press ENTER.
4. Under Adapter Settings, configure the following, as shown in
a.
b.
CU0354602-00 A
4-25) or a dynamic IP address (see
4-28).
Set Enable ROM to Enabled.
Set IP Format to IPv6.
4–Boot Configuration
iBFT Boot Setup (iSCSI)
"Setting Up a
"Setting Up a
Figure 4-17:
4-25