Get Started; Connect Power; Turn On - Philips DS3400/12 User Manual

3 Get started

Always follow the instructions in this chapter in
sequence.

Connect power

This docking speaker can be powered by either
AC power or batteries.
Option 1: AC power
Caution
•
Risk of product damage! Make sure that the power
supply voltage matches the voltage printed on the
bottom of the unit.
•
Risk of electric shock! When you unplug the AC
adaptor, always pull the plug from the socket. Never
pull the cord.
Connect the AC power adaptor to:
• the power socket at the back of the
docking speaker.
• the wall socket.
5 EN
Option 2: Battery power
Caution
•
Risk of explosion! Keep batteries away from heat,
sunshine or fire. Never discard batteries in fire.
•
Remove batteries if they are exhausted or will not be
used for a long time.
•
Batteries contain chemical substances, so they should
be disposed of properly.
Open the battery compartment.
1
Insert 4 x 1.5V AA batteries with correct
polarity (+/-) as indicated.
2
Close the battery compartment.

Turn on

Press to turn the docking speaker on.
» The /
Switch to standby mode
The docking speaker switches to standby mode
in the following situation:
• Press again;
• The speaker is idle for 15 minutes
when powered by AC supply.
» The /
4X1.5V UM3/LR6
LED indicators light up.
LED indicators light off.