Contents 1 Important 2 Your Docking Speaker Introduction What's in the box Overview of the main unit 3 Get started Connect power Turn on 4 Play Play from iPod/iPhone Play from an external device Adjust volume 5 Product information 6SHFLÀFDWLRQV 6 Troubleshooting 7 Notice Disposal of your old product and...
Apparatus shall not be exposed to 1 Important dripping or splashing. Do not place any sources of danger on the DSSDUDWXV HJ OLTXLG ÀOOHG REMHFWV OLJKWHG Read these instructions. FDQGOHV Heed all warnings. The USB socket is for data transmission ...
ZHOFRPH WR 3KLOLSV 7R IXOO\ EHQHÀW IURP WKH support that Philips offers, register your product at www.philips.com/welcome. If you contact Philips, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the bottom of the apparatus.
Open the battery compartment. 3 Get started Insert 4 x 1.5V AA batteries with correct SRODULW\ DV LQGLFDWHG Close the battery compartment. Always follow the instructions in this chapter in sequence. Connect power This docking speaker can be powered by either AC power or batteries.
Page 6
Switch to standby mode The docking speaker switches to standby mode in the following situation: Press again; In AC power supply, the speaker is idle for 15 minutes; or In battery power supply, the iPod/iPhone or external audio device is disconnected with the docking speaker.
3G iPhone Listen to the iPod/iPhone Philips DockStudio app brings a suite of new features to your docking speaker. To enjoy more features, you are recommended to install the free DockStudio app. Launch the app after the installation.
Page 8
Follow the on-screen instructions to FRPSOHWH WKH ÀUPZDUH XSGDWH With the DockStudio app, you can enjoy music, set clock and alarm, adjust sound settings, and update ÀUPZDUH LI QHFHVVDU\ 8SGDWH ÀUPZDUH ,I ÀUPZDUH XSGDWH LV DYDLODEOH WKH DockStudio app will search for it automatically and ask you to download it.
Sync iPod/iPhone with PC Note 0DNH VXUH WKDW L7XQHV KDV EHHQ FRQÀJXUHG SURSHUO\ LQ your PC. Insert the iPod/iPhone in the dock. Press to switch to standby mode. » The LED indicators light off. Connect your docking speaker and PC with a USB cable.
» The docking speaker switches to MP3 link mode automatically. Play audio on the device (see the device's XVHU PDQXDO Adjust volume Press +/- on your docking speaker; or Adjust the volume control of your iPod/ iPhone or external device. ...
5 Product information Note Product information is subject to change without prior notice. 6SHFLÀFDWLRQV $PSOLÀHU Rated Output Power 2 X 5 W RMS General information Power supply Model: AS190-090- - AC Power $% 3KLOLSV Input: 100-240 V ~, 50/60Hz, 0.7A; Output: 9 V 1.9 A;...
If you encounter problems when using this device, check the following points before requesting service. If the problem remains unsolved, go to the Philips Web page (www. SKLOLSVFRPVXSSRUW :KHQ \RX FRQWDFW 3KLOLSV make sure that the device is nearby and the model number and serial number are available.
All unnecessary packaging has been omitted. device that are not expressly approved by We have tried to make the packaging easy to Philips Consumer Lifestyle may void the user’s VHSDUDWH LQWR WKUHH PDWHULDOV FDUGERDUG ER[ authority to operate the equipment.