HP 3PAR StoreServ 7000 Specification page 11

QuickSpecs
Configuration
HP 3PAR StoreServ 7400 Upgrade Controller Node Pair
Use the HP 3PAR StoreServ 7400 Upgrade Node Pair to convert an existing previously installed HP 3PAR StoreServ 7400 2-node
Storage Base into a 4-node configuration.
Step 2 - Choose Host Adapter
Host adapters can be ordered separately to be installed in the field or they can be factory configured into controller nodes. Host adapter
cards provide the array with additional FC ports or with 10Gb/sec iSCSI/FCoE ports. The additional FC ports can be used for connection to
hosts or used to connect to other HP 3PAR StoreServ Storage systems in a Remote Copy relationship. The iSCSI/FCoE ports permit host
connection in iSCSI and FCoE environments.
NOTE: FCoE functionality will be enabled in a later release.
HP 3PAR StoreServ 7000 Host Adapters
HP 3PAR StoreServ 7000 4-port 8Gb/sec Fibre Channel Adapter
HP 3PAR StoreServ 7000 2-port 10Gb/sec iSCSI/FCoE Adapter
the HP 3PAR StoreServ 7400 2-node Storage Base and (2) QK753B HP SN6000B
16 Gb/s 48-port/24-port Active FC Switches -dual power. Each switch comes with
rack mount kit (including rails, mounting hardware, and plenum), RJ-45 serial
cable with adaptor for RJ-45 to DB9, power cords, and SAN Network Advisor DVD.
Also included is a 3 year warranty for the switches.
NOTE: Requires optical transceivers and switch cabling which must be supplied
separately.
All base configurations include built-in Gigabit Ethernet ports for management
and Remote Copy over IP.
HP 3PAR StoreServ 7400 Upgrade Node Pair
Used to upgrade the QR483A HP 3PAR StoreServ 7400 2-node Storage Base to a
4-node configuration.
One (1) pair of controller nodes beyond the base configuration is supported on
the 3PAR StoreServ 7400.
The 3PAR StoreServ 7400 Upgrade Node Pair includes (2) controller nodes, 32 GB
of cache, (24) small form factor drive bays, (4) built-in 8 Gb/sec FC ports, (4) 8Gb
shortwave FC SFP, (2) PCIe adapter slots for host adapter cards - one slot per
node, (4) 2m SAS cables, (4) node link cables, (1) mounting rail kit, and power
cords
The upgrade node pair includes built-in Gigabit Ethernet ports for management
and Remote Copy over IP.
Used in the Storage Base products (QR482A, QR483A, and QR485A) and the
Upgrade Node Pair (QR484A).
Because the Storage Base products and the Upgrade Node Pair include built-in FC
ports, the host adapter cards are optional.
QR486A and QR487A include one adapter card each. Adapters must be purchased
in pairs.
The QR486A includes (4) 8 Gb/s shortwave FC SFPs and the QR487A includes (2) 10
Gb/s SFPs.
Each node in a node pair (a node pair is composed of the two controller nodes in a
single 2U enclosure) must have the same number and type of adapters. FC and
DA - 14433 North America — Version 6 — February 19, 2013
HP 3PAR StoreServ 7000 Storage
QR484A
QR486A
QR487A
Page 11