Cisco Aironet 3502P Getting Started Manual page 3

Warning This product relies on the building's installation for short-circuit (overcurrent)
protection. Ensure that the protective device is rated not greater than:
20A. Statement 1005
Warning Do not operate your wireless network device near unshielded blasting caps or in an
explosive environment unless the device has been modified to be especially qualified for
such use. Statement 245B
The fasteners you use to mount an access point on a ceiling must be capable of
Caution
maintaining a minimum pullout force of 20 lbs (9 kg) and must use all 4 indented holes
on the mounting bracket.
This product and all interconnected equipment must be installed indoors within the same
Caution
building, including the associated LAN connections as defined by Environment A of the
IEEE 802.af Standard.
The access point is suitable for use in environmental air space in accordance with section
Note
300.22.C of the National Electrical Code and sections 2-128, 12-010(3), and 12-100 of the
Canadian Electrical Code, Part 1, C22.1. You should not install the power supply or power
injector in air handling spaces.
Use only with listed ITE equipment.
Note
3
Unpacking
Follow these steps:
Unpack and remove the access point and the accessory kit from the shipping box.
Step 1
Return any packing material to the shipping container and save it for future use.
Step 2
3