Declaration Of Conformity Statements; Configuring Dhcp Option 43 And Dhcp Option - Cisco Aironet 3502P Getting Started Manual

Australia
This system has been evaluated for RF exposure for Humans as referenced in the Australian Radiation
Protection standard and has been evaluated to the ICNIRP (International Commission on
Non-Ionizing Radiation Protection) limits. The minimum separation distance from the antenna to
general bystander is 20cm (7.9 inches). Installations utilizing antennas with gain greater than 10 dBi
will assure a separation distance of at least 30 cm.

Declaration of Conformity Statements

All the Declaration of Conformity statements related to this product can be found at the following
location: http://www.ciscofax.com
10

Configuring DHCP Option 43 and DHCP Option 60

This section contains a DHCP Option 43 configuration example on a Windows 2003 Enterprise DHCP
server for use with Cisco Aironet lightweight access points. For other DHCP server implementations,
consult product documentation for configuring DHCP Option 43. In Option 43, you should use the
IP address of the controller management interface.
DHCP Option 43 is limited to one access point type per DHCP pool. You must configure a
Note
separate DHCP pool for each access point type.
The 3502P access point uses the type-length-value (TLV) format for DHCP Option 43. DHCP servers
must be programmed to return the option based on the access point's DHCP Vendor Class Identifier
(VCI) string (DHCP Option 60). The VCI string for the 3502P access point is:
Cisco AP c3502
The format of the TLV block is listed below:
• Type: 0xf1 (decimal 241)
• Length: Number of controller IP addresses * 4
• Value: List of WLC management interfaces
To configure DHCP Option 43 in the embedded Cisco IOS DHCP server, follow these steps:
Step 1 Enter configuration mode at the Cisco IOS CLI.
Create the DHCP pool, including the necessary parameters such as default router and name
Step 2
server. A DHCP scope example is as follows:
ip dhcp pool <pool name>
26