Troubleshooting - ezee quando User Manual

No. of Explanation
blinks
ON No response on motor
2 Brake lever cut off in
contact
3 Brake lever cut off in
contact
4 Throttle not in position
5 Throttle failure
6 low voltage
7 excessively high voltage
8 Hall sensor in motor
faulty
9 Supply 3 phase wire
10 Controller overheating

Troubleshooting

Solution
lost connection on 5V wire to motor , check
connectors at front fork
check brake lever spring, brake levers should
return to position (applicable with electric cut-off
levers)
check wiring connection, inspect for damage to
the battery level gauge
check if throttle spring is faulty
Ground + signal wire to throttle shorted
5V+ signal wire to throttle shorted
Moisture penetration / leave it to dry
Check throttle connections and cable, or replace
Activated when voltage drops below 30.5 V .This
continue to blink and will stop when voltage
recovers to 34V, Or when the main switch is pow-
ered off. Battery charging
Battery voltage is above 44 V./ do not use battery
that is not supplied by eZee, contact your eZee
dealer
One or more hall sensor disconnected or faulty.
Check connector at the front fork. If connector
is OK, contact your eZee dealer
Check phase wires at the front fork. Contact your
eZee dealer
Motor continue to function but the amps directed
will be lessened to reduce the load and cool
controller
21