Advertisement
Quick Links
Congratulations on your purchase of the EZee Glider! Your glider is designed for years of nearly carefree use by
your child. These instructions include how to set up your glider and the maintenance procedures which you should
perform to ensure long-lasting use and optimal performance
Tools needed for Assembly:
Wrench (included)
Philips Screwdriver (not included)
Assembly Instructions
Your Glider comes partially assembled. The only things that you need to do are install the front wheel, install and
adjust the handlebars, and put in the seat.
Installing and Adjusting the Handle bar:
1.
Remove the plastic cover on the end of the handlebar stem by first removing the Velcro cover on top of the
handlebar stem and then loosening the chrome 12 mm bolt by 2-3 Turns to the left. The plastic cover should
slide off.
EZee Glider Manual
Advertisement
Related Manuals for ezee Glider
Summary of Contents for ezee Glider
- Page 1 Philips Screwdriver (not included) Assembly Instructions Your Glider comes partially assembled. The only things that you need to do are install the front wheel, install and adjust the handlebars, and put in the seat. Installing and Adjusting the Handle bar: Remove the plastic cover on the end of the handlebar stem by first removing the Velcro cover on top of the handlebar stem and then loosening the chrome 12 mm bolt by 2-3 Turns to the left.
- Page 2 2. Once the bolt is loose and the cover has been removed, insert the handlebars. Twist the handlebars so that it is perpendicular to the frame. 3. Tighten 12 mm bolt with provided wrench on top of stem until front wheel and handlebars won’t twist. 4.
- Page 3 Installing and Adjusting Seat The proper seat height is achieved when your child can put both feet on the ground at the same time when seated. If the seat is too high or too low, use the quick-release to loosen the seat clamp bolt, adjust the seat to the proper height, and retighten quick release.
- Page 4 Insert the wheel into the fork and replace the hook washers onto the axle so the tab fits into the corresponding hole, then put on flat washer and tighten the axle nuts with the provided tool. Brake Handle Adjustment The brake handle comes attached by the factory but you can adjust it for ease of use. To adjust the brake, use a Philips screwdriver to loosen the screw holding the lever to the handlebars and set the brake lever distance so that the child can easily reach it, then retighten the screw.
- Page 5 should spin freely but stop when lever is squeezed. When the bike is new there is a break-in period, wait until the bike has been used for a couple of hours then try to adjust it again. If the brake is too tight after you have turned the barrel adjuster clockwise all the way in or too loose after adjusting barrel counter clockwise all the way out, the cable will need to be adjusted.
- Page 6 Before Riding Before your child begins riding the glider, here is some important information to read first. Adults should explain this information to a child, or anyone else who is otherwise not able to understand this information.
- Page 7 Operation The EZee Glider works by allowing children to learn at their own pace while feeling safe that they are not going to fall. The bike was designed with a low-center of gravity and slack head angle for better control and balance.
-
Page 8: Maintenance
Carefully inspect your glider for the following signs of fatigue: Dents Cracks Deformation If any part shows signs of damage, replace the part before riding the glider If you have any questions about the assembly of this Glider: Email csupport@glidebikes.com...