Names And Functions Of Remote Control Unit - Hitachi RAS-S10CYK Instruction Manual

NAMES AND FUNCTIONS OF REMOTE CONTROL UNIT

REMOTE CONTROLLER
This controls the operation of the indoor unit. The range of control is about 7 meters. If indoor lighting
is controlled electronically, the range of control may be shorter.
This unit can be fixed on a wall using the fixture provided. Before fixing it, make sure the indoor unit can
be controlled from the remote controller.
SUPER COOL / START
CIRCULATION / START
DEHUMIDIFY / START
COOLING / START
FAN
FAN SPEED
LOW
MED
HI
SLEEP TIMER
STOP
TIMER SELECTOR
ON TIMER
OFF TIMER
AUTO SWING
EE1-RAS/RAC-S10CYK/S13CYK
Transmission sign
G
The transmission sign blinks when a signal is sent.
Display
G
This indicates the room temperature selected, timer status, function
and intensity of circulation selected.
CIRCULATION button
G
Use this button to set air circulation in the room or start operation.
DEHUMIDIFYING button
G
Use this button to dehumidify the room or start operation.
COOLING button
G
Use this button to set cooling mode in the room or start operation.
RESET button
G
SUPER COOLING button
G
Use this button to set super cooling operation or start operation.
STOP button
G
Press this button to stop operation only.
SLEEP button
G
Use this button to set the sleep timer.
FAN SPEED selector
G
This determines the fan speed. Every time you press this button,
the intensity of circulation will change from
to (MED) to (LOW).
AUTO SWING button
G
Controls the angle of the horizontal air deflector.
TEMPERATURE button
G
Use this button to raise or lower the temperature setting. (Keep
pressed, and the value will change more quickly.)
OFF-TIMER button
G
ON-TIMER button
G
Precautions for Use
Do not put the remote controller in the following places.
G
G In direct sunlight.
G In the vicinity of a heater.
Handle the remote controller carefully. Do not drop it on the
G
floor, and protect it from water.
Once the outdoor unit stops, it will not restart for about 3 minutes
G
(unless you turn the power switch off and on or unplug the
power cord and plug it in again).
This is to protect the device and does not indicate a failure.
If you press the FUNCTION selector button during operation,
G
the device may stop for about 3 minutes for protection.
– 6 –
6
Select the turn OFF time.
Select the turn ON time.
10/2/09, 9:21
(AUTO) to (HI)