Attaching The Air Cleansing And Deodorizing Filters - Hitachi RAS-18KH(T1) Instruction Manual

ATTACHING THE AIR CLEANSING AND DEODORIZING FILTERS

CAUTION
!
Cleaning and maintenance must be carried out only by qualifi ed service personal. Before cleaning,
stop operation and switch off the power supply.
1
Open the front panel.
Pull up the front panel by holding it at both sides
●
with both hands.
2
Remove the fi lter.
Push upward to release the claws and pull out the
●
fi lter.
3
Attaching the air cleansing and deodorizing fi lters
to the fi lter.
● Attach the air cleansing and deodorizing fi lters to
the frame by gently compress its both sides and
release after insertion into fi lter frame.
CAUTION
!
Do not bend the air cleansing
and deodorizing fi lter as it may
cause damage to the structure.
4
Attach the fi lters.
Attach the fi lters by ensuring that the surface written
●
"FRONT" is facing front.
After attaching the fi lters, push the front panel at
●
three arrow portion as shown in fi gure and close it.
NOTE
In case of removing the air cleansing and deodorizing fi lters, please follow the above procedures.
●
The cooling capacity is slightly weakened and the cooling speed becomes slower when the air
●
cleansing and deodorizing fi lters are used. So, set the fan speed to "HIGH" when using it in this
condition.
● Air cleansing and deodorizing fi lters are washable and reusable up to 20 times by using vacuum
cleaner or water rinse under running tap water. Type number for this air cleansing filter is
<SPX-CFH5>. Please use this number for ordering when you want to renew it.
● Do not operate the air conditioner without fi lter. Dust may enter the air conditioner and fault may
occur.
RAS-18KH(T1)-24GH4 (2).indd 20 RAS-18KH(T1)-24GH4 (2).indd 20
Claws
(4 places)
– 20 –
5/12/10 10:22 AM 5/12/10 10:22 AM