Names And Functions Of Remote Control Unit - Hitachi RAS-10CZJ Instruction Manual

Split type indoor unit/outdoor unit
Table of Contents

Advertisement

NAMES AND FUNCTIONS OF REMOTE CONTROL UNIT

REMOTE CONTROLLER
This controls the operation of the indoor unit.
This unit can be fi xed on a wall using the fixture provided. Before fixing it, make sure the indoor unit can be
controlled from the remote controller.
CIRCULATION / START
DEHUMIDIFY / START
COOLING / START
FAN
FAN SPEED
LOW
MED
HI
SLEEP TIMER
STOP
TIMER SELECTOR
ON TIMER
OFF TIMER
AUTO SWING
Signal range to reach indoor unit is about 7 meters.
Transmission sign
The transmission sign blinks when a signal is sent.
Display
This indicates the room temperature selected, current time, timer status,
function and intensity of circulation selected.
AIR CIRCULATION button
Use this button to set air circulation in the room or start operation.
DEHUMIDIFYING button
Use this button to reduce water quantity in the room or start operation.
COOLING button
Use this button to set cooling mode in the room or start operation.
RESET button
STOP button
Press this button to stop operation only.
SLEEP button
Use this button to set the sleep timer.
FAN SPEED selector
This determines the fan speed. Each time you press this button,the
intensity of circulation will change from
to
(LOW) (during the
MED to
LOW).
AUTO SWING button
Controls the angle of the horizontal air deflector and to turn off filter
lamp.
TEMPERATURE button
Use this button to raise or lower the temperature setting. (Keep
pressed, and the value will change more quickly.)
OFF-TIMER button Select the turn OFF time.
ON-TIMER button Select the turn ON time.
Precautions for Use
Do not put the remote controller in the following places.
In direct sunlight.
In the vicinity of a heater.
Handle the remote controller carefully. Do not drop it on the floor, and
protect it from water.
Once the outdoor unit stops, it will not restart for about 3 minutes
(unless you turn the power switch off and on or unplug the power
cord and plug it in again).
This is to protect the device and does not indicate a failure.
- 6 -
(AUTO) to
(AIR CIRCULATION) mode, from
(HI) to
(MED)
HI to

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents