Table of Contents
Advertisement
Q
Is the exposure adjusted correctly?
A
Adjust the exposure correctly using [Exposure]. (See "Adjusting the Exposure (Density)," on p. 5-3.)
Copies are dirty.
Q
Is the platen glass or the platen glass cover clean?
A
Clean the platen glass or the platen glass cover. (See "Cleaning the Scanning Area," on p. 8-1.)
Q
Is the cartridge free of damage?
A
If there is a scratch on the cartridge, replace with a new one. (See "Replacing the Cartridge," on p.
8-5.)
Q
Is the machine adjusted to room temperature? If not, condensation might build up inside the
machine.
A
Allow at least 2 hours for the machine to adjust to room temperature before attempting to use it.
Q
Is the machine installed in a stable location?
A
Install the machine in a proper location. (See Chapter 1, "Safety Instructions," in the Quick
Reference Guide.)
Copies are too dark or too light.
Q
Is the exposure adjusted correctly?
A
Adjust the exposure correctly using [Exposure]. (See "Adjusting the Exposure (Density)," on p. 5-3.)
Q
Is the machine in the toner saver mode?
A
Set <TONER SAVER MODE> to <OFF> in <COMMON SETTINGS> of the Menu. (See <2. TONER
SAVER MODE> of "Menu Descriptions," on p. 10-2.)
The printouts are partly missing or shaded when you make copies on heavy paper.
Q
Is the paper type set correctly?
A
Select <HEAVY PAPER> or <HEAVY PAPER H> in <PAPER TYPE> in <PAPER SETTINGS> of the
Menu. (See "Specifying the Paper Type," on p. 2-9.)
9
9-13
Advertisement
Table of Contents
