Verifying Normal Operation - Splendide WD2000S Training Manual

DISPLAY
Follow these steps in the order they are listed to test the washer-dryer for normal operation.
We recommend that you ALWAYS perform this test as the last step of your repair. It takes approximately 8 min. to complete.
Introduction
The following instructions explain how to test the washer-dryer
to make sure everything's working properly. Keep in mind, this
appliance operates diff erently than some of the previous Splendide
models you may be familiar with.
It's important to note the following diff erences:
• The timer WILL NOT advance like a traditional, mechanical timer.
It only sends a signal to the control board.
• All of the timing is controlled by a microprocessor on the board,
so the Dry Time knob WILL NOT move, or "count down" the time.
• If you try to advance the Program Selector WITHOUT properly
You Select
1. "30" on Dry Time knob
2. 'Super' wash cycle
3. Any 'Reset'
4. Any 'Spin'
5. Any 'Reset'
6. Any 'Dry'
7. Any 'Reset'
8. "0" on Dry Time knob
9. ON/OFF (out)
62
Tech Tips

Verifying Normal Operation

Correct Washer-Dryer Response
After 5 seconds, Auto Dry LED turns ON. 'Status/Door Lock'
LED fl ashes RAPIDLY, then SLOWLY.
Fill by water inlet valves. Two-way basket rotation.
After 5 seconds, 'Status/Door Lock' LED fl ashes QUICKLY.
Drain Pump turns ON. Basket rotates and ramps up.
After 5 seconds, 'Status/Door Lock' LED fl ashes QUICKLY.
Fan turns ON. Two-way basket rotation.
After 5 seconds, 'Status/Door Lock LED fl ashes QUICKLY.
' A uto Dry' LED turns OFF. Wait 1-2 minutes. 'Status/Door
Lock' LED fl ashes QUICKLY, then SLOWLY when the door
unlocks.
'Status/Door Lock' LED turns OFF.
-- End --
resetting the machine by choosing a Reset position, the Program
Selector will automatically advance to the original setting.
• To be sure that the machine is properly reset, it's a good idea to
leave the power ON so you can monitor the Status/Door Lock
LED. This LED will fl ash RAPIDLY when the selector is in a 'Reset'
position. NOTE: If the LED stays solid, the machine has not reset.
Before beginning the test, remove all items from the drum,
close the door, and press the ON/OFF button (in). Next, Reset the
washer-dryer. To do this, advance the Cycle Selector to a 'Reset'
position and wait 10 seconds.
Components Checked
LED'S, Door Lock
System.
Inlet Valves, Dispenser, Main Motor.
Drain Pump, Main Motor.
Fan Motor
LED's, Door Lock
System.