Fault Code / Testing Procedure Chart - Splendide WD2000S Training Manual

See "Explanation of the Fault Codes" on the previous page to determine the Fault Code that the washer-dryer is displaying. Then, follow the recommended
DISPLAY
testing procedure to troubleshoot the problem. Call Westland Sales if the machine continues displaying the Fault Code.
Fault Code Explanation / Recommended Testing Procedure
F01 Short-circuited Motor TRIAC on Module Board
• Verify Drive Motor connections and wiring. See "Component Testing".
• Open the door of the washer-dryer and verify the drum spins freely and is not hitting anything.
F02 Blocked Motor/Tachometer Open/Short-Circuited
• Verify Drive Motor connections and wiring. See "Component Testing".
• Verify motor operation. Refer to "Test Running the Main Motor with AC Voltage" pg 47.
• Open the door of the washer-dryer and verify the drum spins freely and is not hitting anything.
F03 Wash NTC Sensor Open/Short-Circuit
• Verify NTC Connections and wiring. See "Component Testing".
F04 Both Empty and Over Flow Signals Present
• Verify Pressure Switch connections and wiring. See "Component Testing".
F05 Blocked Pump/Pressure Switch Stuck on Empty
• Check Pump Pre-Chamber for blockage. See "Component Access".
• Verify pump connector and wiring. See "Component Testing".
• Verify Pressure Switch connections and wiring. See "Component Testing".
F06 Selector Binary Code Not Found
• Verify Program Selector connections and wiring, See "Component Testing".
F07 Not Applicable
F08 Missing or Incorrect ON/OFF Switch Signal
• Verify ON/OFF Switch connections and wiring. See "Component Testing".
56
Diagnosis & Troubleshooting

Fault Code / Testing Procedure Chart