The Control Unit, and Mattress are warranted under the terms and conditions of the Graham Field Health Products warranty in place at the time of purchase. A copy of the warranty is available upon request. Graham Field Health Products disclaims all implied warranties including, but not limited to, the implied warranties of merchantability and of fitness for a particular purpose.
Lumex ® AltaDyne AutoFloat 2.0 Symbols Attention, consult accompanying document Type BF equipment 3.0 Indications for Use This device is intended to assist in treating and preventing pressure ulcers. 4.0 Contraindication Air support treatment is not recommended when spinal stability is a concern. 5.0 Safety Precautions Review the following SAFETY PRECAUTIONS prior to using the AltaDyne Auto Float Risk of electric shock.
Lumex ® AltaDyne AutoFloat Description/Features 6.0 Description The AltaDyne AutoFloat is a portable air flotation system with on-demand alternating low pressure treatment, designed to provide benefit to patients suffering from, or at risk of, developing pressure ulcers. The system, consisting of a Control Unit and Air Flotation Mattress with it’s Top Sheet, is designed to provide pressure management and patient comfort.
Lumex ® AltaDyne AutoFloat 8.0 Operator Control Panel 1. ON/STANDBY switches Control Unit between On and STANDBY modes. 2. POWER INDICATOR LED indicates AC power is present to the Control Unit. 3. MODE SELECT Press repeatedly to toggle through operating modes, Auto/Float, Auto/A/P, Manual/Float and Manual/A/P.
Lumex ® AltaDyne AutoFloat 9.0 Setting Up the System Mattress Mattress 1. Place the mattress on the bed frame with the connecting hoses at the foot of the bed. 2. Before securing the mattress straps, raise the head and foot ends of the bed frame. Raise the side rails. Loosely, secure mattress to bed frame by looping the nylon straps on mattress through the bed frame and then back through the D-rings on mattress.
Lumex ® AltaDyne AutoFloat If the patient sinks into the mattress for any reason, (such as elevation of the head section or other part of the bed) the Control Unit will automatically increase the inflation level until the appropriate flotation height is again realized. Disconnecting the mattress sensor cord from the Control Unit while in automatic mode will cause an audible alarm to sound and indicators adjacent to the ALARM SILENCE and AUTO icons to flash.
Lumex ® AltaDyne AutoFloat 12.0 CPR (Cardio Pulmonary Resuscitation) To deflate mattress for CPR: 1. Disconnect the dual quick-connect couplings of the mattress hose from the Control Unit. Mattress will deflate in approximately 15-20 seconds. 2. Proceed with CPR procedures. 13.0 System Cleaning, Care and Storage 13.1 Cleaning Disconnect the AC power cord from the wall outlet before attempting to clean the Control Unit.
Lumex ® AltaDyne AutoFloat 14.0 Troubleshooting SYMPTOM: Make certain the air hoses are not kinked, cracked, or split. Verify the hose couplings Mattress does not are fully engaged to controller. Verify that all 20 air cells are connected to the air manifold inflate or is too soft.
Need help?
Do you have a question about the ALTADYNE 753003 and is the answer not in the manual?
Questions and answers