Wall Fixings - Very Important - Creda 70305S Assembly Instruction Manual

7
THE FOLLOWING MUST BE APPLIED
WHEN FIXING THE HEATER TO THE
WALL BRACKET
i) If no skirting board is present secure the heater
through the wall bracket slots closest to the wall.
ii) If 100mm (4") skirting is present secure the heater
through the outer slots.
iii) If skirting taller than 150mm (6") is present this must
be reduced to 150mm (6") over the entire width of
the heater plus 25mm (1") at each end.
Do not fully tighten these screws until the bricks are loaded
into the heater as some settling of the heater may occur.
NOTE: NEVER REMOVE THESE SCREWS WITHOUT FIRST UNLOADING THE HEATER.
8
Remove one element to allow access for the back row
of bricks. On the SFH24AW remove the element to
the right of centre and on the SFH18AW remove the
central element.
Loosen the two screws securing the element tails in the ceramic
connector block, and lift the element up and out of the heater.
ENSURE THAT ALL PACKAGING MATERIAL IS REMOVED FROM THE BRICKS BEFORE FITTING THEM.

WALL FIXINGS - VERY IMPORTANT

Carefully fit the bottom row of the back layer
of bricks placing the two end bricks into
position first. Ensure that the recess
in the bricks is towards the rear of
the heater. Repeat this with the top row of the
back layer of bricks. Refit the element which had been
removed by feeding the tails down through the hole in the
base insulation and into the connector block. Ensure the
element is fully pushed home, then securely tighten the two
screws in the block.
You must fit a
retaining screw at
each end of the
heater.
9