Creda NewEra 79348S Assembly Instruction Manual page 6

3
When bracket is securely fixed, replace
the heater under the bracket angle and
align screw holes on heaters ends.
There are two fixing slots at each end of heater,
allowing different stand-offs for different thicknesses
of skirting board. Do not fully tighten these screws
until the bricks are loaded into the heater as some
settling of the heater may occur.
NOTE: NEVER REMOVE THESE SCREWS WITHOUT
FIRST UNLOADING THE HEATER.
See also figure 2 regarding carpets where
appropriate.
Note: Max. skirting size is 15 x 120mm.
Note that the smallest wall spacing should be used
only when the skirting board is of the modern slim type, or there is no skirting board at all. THE HEATER MUST
STAND VERTICAL
4
A clear space of at least 3" (75mm)
must be left at either side of the heater,
and any projections or shelves must
be at least 10" (250mm) above the
heater casing. Curtains must not
be draped around or in contact with
the casing. A shelf unit is separately
available for fitting above heaters.
NOTE: Removal of the lower front panel is only possible after the top and main front panel assembly has
been removed. First, remove the two black screws situated on the lower front face, then remove the four side
screws. The lower front panel will then pull forward, clear of the heater.
WALL FIXINGS - VERY IMPORTANT
The top panel and front panel are joined and
should be removed as one assembly. To do
this, remove the screws fixing the rear flange
of the top panel, and remove the screws along
the bottom edge of the front panel. Carefully swing out
bottom of front panel and lift assembly clear of casing,
this operation also removes the control knobs under the
flap. Put assembly in a safe place to avoid damage to
paint etc.
You must fit a
retaining screw at
each end of the
heater.
5