Customizing The Blue Dome Led Display; Turning The Led On And Off - NETGEAR RangeMax WPN824N User Manual

• To allow access from any IP address on the Internet, select Everyone.
• To allow access from a range of IP addresses on the Internet, select IP Address Range.
Enter a beginning and ending IP address to define the allowed range.
• To allow access from a single IP address on the Internet, select Only This Computer.
Enter the IP address that will be allowed access.
3. Specify the port number for accessing the management interface.
Normal Web browser access uses the standard HTTP service port 80. For greater security,
enter a custom port number for the remote management Web interface. Choose a number
between 1024 and 65535, but do not use the number of any common service port. The default
is 8080, which is a common alternate for HTTP.
4. Click Apply to have your changes take effect.
Note: When accessing your router from the Internet, enter your router's WAN IP address
into your browser's address or location field, followed by a colon (:) and the
custom port number. For example, if your external address is 134.177.0.123 and
you use port number 8080, then enter http://134.177.0.123:8080 in your browser.

Customizing the Blue Dome LED Display

You can customize the behavior of the LED on your router's blue Dome.

Turning the LED On and Off

You can turn the blue Dome LED on and off in either of two ways:
• Press down on the blue Dome. This toggles the LED display on and off.
• Set the LED to be on or off on the Network Monitor Display Settings screen.
To turn the LED on or off from the Network Monitor Display Settings screen:
Using Network Monitoring Tools
RangeMax Wireless-N 150 Router WPN824N User Manual
v1.0, February 2010
6-13