Support; Notices - Cardo Systems SCALA RIDER G4 User Manual

Using your G4 with another G4 and another scala rider model
(such as a Q2, Solo, FM, or TeamSet [Driver] headset)
1. Proceed with setup as in section 9.10b above for pairing the
second G4.
2. Proceed with setup as in section 9.11a or 9.11b above
according to the headset you want to use.
Example:
For pairing your G4 with another G4 and a scala rider FM headset:
1. Pair your G4 with the second G4 as described in section 9.10a.,
using CHANNEL "A".
2. Pair your G4 with the FM as described in section 9.11b., using
CHANNEL "B" [For Rider-to-Passenger use only]
Initiate Intercom calls from scala rider G4
There are two ways to start an Intercom call with your paired headsets
while the headset is in Standby mode:
VOICE CONNECT:
Start talking loudly
Once you start talking loudly, an
Intercom call will be established
with both paired headsets, CHAN-
NEL "A" and CHANNEL "B" (if both
are available).

10. SUPPORT

For additional information please visit our website at
www.cardosystems.com
FAQ: www.cardosystems.com/support/faq
or contact us at: support@cardosystems.com
Phone:
USA and Canada: + 1-800-488-0363
International: +4989 450 36819
CHANNEL BUTTON CONNECT:
Single tap the CHANNEL "A" But-
ton to add or remove the CHANNEL
"A" headset from an Intercom call.
Single tap the CHANNEL "B" But-
ton to add or remove the CHANNEL
"B" headset from an intercom call.

11. NOTICES

Federal Communications Commission (FCC) Statement
15.21
You are cautioned that changes or modifications not expressly approved by
the part responsible for compliance could void the user's authority to operate
the equipment.
15.105(b)
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Operation is subject to the following two conditions:
1) this device may not cause interference and
2) this device must accept any interference, including interference that may
cause undesired operation of the device.
scala rider G4 21
® ™