Advertisement
NOTE: To access internal jumper options: 1) disconnect the unit from AC power 2) remove the top panel 3) lay the unit with the front
panel facing away 4) using needle-nose pliers, move the desired jumper straps as described below 5) replace the top panel.
75 Ohm Back-Termination:
However, internal jumpers allow selection of 75 ohm 'back-termination', which is required only for specific video applications. To select 75
ohm 'back-termination', move the Input 1~4 jumper straps (J102~J402) down one pin, to the "75 OHMS" position (see diagram below).
J402
HI-Z
75
OHMS
INPUT 4
BNC
RCA
jack
jack
Internal Infrared Receiver Bypass: An internal jumper allows the Internal Infrared Receiver to be bypassed. To bypass the Internal
Infrared Receiver, move the "INTERNAL RECV" jumper strap (J3) left one pin, to the "OUT" position (see diagram below).
Logic Inputs Pin Assignments: When controlling the VSX41 via logic outputs from an ADVANTAGE
allow VSX41 Logic Inputs to be assigned to corresponding pins for those products (refer to AGII & DRC4+4 manuals). To assign Logic
Input pins, move the "SOURCE SELECT" jumper straps (J2) to the desired Logic Input Pin Number positions (see diagram below).
Remote Control Button Assignment: When using Remote Output to control additional ADVANTAGE products, VSX41 Channel Select
functions may be assigned to the next row of buttons, to avoid conflict with the other products. To assign Channel Select to the second
row of remote control buttons, move the "OPTION Z" jumper strap (J4) down one pin, to the "OFF" position (see diagram below).
From the factory, Inputs 1~4 have 3.9k ohm 'back-termination', which is appropriate for most applications.
J302
HI-Z
75
OHMS
INPUT 3
BNC
RCA
jack
jack
ERROR
IR
ON
OPTIONS
J202
HI-Z
75
OHMS
INPUT 2
BNC
RCA
jack
jack
IR1
J3
OUT IN
INTERNAL RECV
SOURCE SELECT
4
3
2
2
1
9 4 8 3 7 6 2 6 1
LOGIC INPUT PIN NUMBER
J4
ON
OPTION
z
OFF
6
J102
HI-Z
75
OHMS
INPUT 1
BNC
RCA
jack
jack
®
AGII or DRC4+4, internal jumpers
Advertisement
